This standard cold shrink tube is specially madefor the telecommunication industry. It is intended to protect joints of jumper wires and antenna or RRU terminal against chemical corrosion and mechanical forces in the installation of antenna feeder system.
This standard cold shrink tube is specially madefor the telecommunication industry. It is intended to protect joints of jumper wires and antenna or RRU terminal against chemical corrosion and mechanical forces in the installation of antenna feeder system.
| Property | Typical value | Test method |
| Tensile strength | ≥7.5MPa | GB/T528 |
| Tear strength | 30kN/m | GB/T529 |
| Elongation | 700% | GB/T528 |
| Volume resistivity | 1.0*1015Ω·cm | GB/T1410 |
Grey Series Cold Shrink Tube
| Part No. | Size | Application Range (mm/inch) | Length after Relaxed (mm/inch) |
| 625-L | Ø25 | 6.3～21/0.25～0.59 | 90～180/3.5～7 |
| 632-L | Ø32 | 10～26/0.39～1.02 | 90～180/3.5～7 |
| 635-L | Ø35 | 12～30/0.47～1.18 | 90～180/3.5～7 |
| 640-L | Ø40 | 12.7～33/0.50～1.30 | 90～450/3.5～17.7 |
| 644-L | Ø44 | 12.7～38/0.50～1.50 | 90～450/3.5～17.7 |
| 653-L | Ø53 | 22～46/0.87～1.81 | 90～500/3.5～19.7 |
| 665-L | Ø65 | 32～58/1.26～2.28 | 90～500/3.5～19.7 |
| 680-L | Ø80 | 37～72/1.46～28.3 | 90～500/3.5～19.7 |
Black Series Cold Shrink Tube
| Part No. | Size | Application Range (mm/inch) | Length after Relaxed (mm/inch) |
| 825-L | Ø25 | 7.3～21/0.29～0.83 | 81.3～203/3.2～8 |
| 835-L | Ø35 | 10.5～30/0.42～1.18 | 178～305/7～12 |
| 840-L | Ø40 | 11.9～34/0.47～1.34 | 140～305/5.5～12 |
| 845-L | Ø45 | 13.5～39/0.53～1.54 | 152～305/6～12 |
| 853-L | Ø53 | 18.2～45/0.72～1.77 | 152～457/6～18 |
| 870-L | Ø70 | 22.4～63/0.88～2.48 | 125～508/5～20 |
